Daikin Applied Fan Array - Daikin Vision Installation And Maintenance Manual

Table of Contents

Advertisement

Daikin Applied Fan Array

WARNING
Closing the damper on an operational fan could send the fan
into surge that could produce fans stall, excessive vibration,
unit damage, or personnel injury.
The Daikin Applied Fan Array is available with optional, factory
mounted VFDs. See OM manuals OM 1190 and 1191 for
details on the Daikin Applied supplied VFD.
Care should be taken when programing and synchronizing the
drives in the Daikin Applied Fan Array such that all fans turn at
the same speed. Fans running at unequal speeds can produce
vibration and could stall a fan. Definition of fan numbering is
given in
Figure
44.
The Daikin Applied Fan Array is standard with a manual block
off plate. The unit will ship with one block off plate that will
come installed on fan 1A. This block off plate is to be removed
before unit operation and stored outside of the air tunnel. In the
event of a lost fan motor, the block off plate is installed on the
non-functional fan to prevent air re-circulation. This is designed
to be a temporary measure unit this fan and/or motor is
replaced. After fan and/or motor replacement the block off plate
is to be removed and stored outside of the air tunnel.
The Daikin Applied Fan Array has an optional gravity actuated
block off damper. These dampers are equipped with counter
weights.
The Daikin Applied Fan Array has an optional actuated block
off damper. These dampers are designed to prevent air
recirculation in the event of a lost fan. Care should be taken
that the damper actuator only be given a close signal if the fan
is not operational (motor burnout for example).
The Daikin Applied Fan Array can be equipped with a fan blank
off plate. See
Figure 45
with a block off plate mounted to fan
3C. If the unit is ordered with the manual block off plate, it will
be installed to fan 1A. This plate has to be removed before
start up.
IM 915-13 • VISION - EXTENDED SIZES
Figure 44: Daikin Applied Fan Array Configuration
6D
5D
4D
6C
5C
4C
6B
5B
4B
6A
5A
4A
Viewed from Fan Inlet End
Figure 45: Fan Array with Block Off Plate
28
Daikin Applied Fan Array
3D
2D
3C
2C
3B
2B
3A
2A
www.DaikinApplied.com
1D
1C
1B
1A

Advertisement

Table of Contents
loading

Table of Contents