Setting The Measurement Mode And Preparing The Target; Measurement With A Prism - Nikon Nivo Series Instruction Manual

Setting the Measurement Mode and Preparing the Target

The Nivo series has two measurement modes: Prism mode (
Reflectorless mode (
down the
settings, page
To set the measurement mode depending on the target you want to measure, see the
following table.
Target
Prism, reflector sheet
Other (reflective materials)
In some cases, you can measure another target that is not appropriate to the set
measurement mode.
Note – The Nivo
function, and Laser Class 1 in the Prism mode.
Don t sight the Prism when the Laser Pointer is on.
'

Measurement with a prism

Do not use a prism with scratches, a dirty surface, or a chipped center. Prisms with
thin edges are recommended.
✓
As the Nivo series is extremely sensitive, multiple reflections on the prism surface
can sometimes cause a significant loss in accuracy.
To maintain the accuracy of your measurements:
N-Prism
or key for one second. For more information, see
[MSR1] [MSR2]
50.
2.M
is Laser Class 3R in the Reflectorless mode and Laser pointer
✕
chipped center
thin edges
). These modes can be changed at any time by holding
Target setting
Prism (Prism mode)
N-Prism (Reflectorless mode)
✕
thick edges
Total Station Nivo Series Instruction Manual
Preparation 2
) and
Prism
Measurement
17