Table of Contents
Advertisement
PTO SHEAR BOLT
1. IMPORTANT: If the PTO shear bolt breaks immediately shut down the tractor and replace the shear bolt.
2. The shear bolts used on this Schulte snow blower and mounting kits are either Grade 2 or Metric Grade
8.8. Refer to the illustrations for help in identification of these grades of bolts.
3. Specified shear bolts and their locations are listed below:
SDX-117 Snow Blower, Auger: 3/8-16 UNC, 2" long, Grade 2
SDX-117 PTO Shaft: M10 METRIC, 50mm, Grade 8.8
NOTE: Both length and grade are important in this specification.
4. Remove the broken shear bolt and replace.
Tighten nut only enough to draw the shear plates together. Do not over tighten nut. Occa-
sionally apply grease to the shear plates.
Replacement of the shear bolt with one of any other grade or size will be considered an un-
authorized modification and the warranty will be void.
SDX-117 11/22
© 2022 Alamo Group Inc.
MAINTENANCE
Maintenance Section 5-8
Advertisement
Table of Contents
