Reversing Or Replacing Blade; Storage; Nuts And Bolts - Schulte SDX-117 Operator's Manual

NOTE: If excessive wear is found, replace the UHMW ring. The guide sleeves must be inspected for wear as
well. If wear on the brass bushing or outer sleeve is found, please replace.

REVERSING OR REPLACING BLADE

1. Occasionally check the blade for wear. If the blade has worn to the point where the moldboard is starting to
wear then reverse it or replace it.
2. Remove the carriage bolts which attach the blade. Reverse or replace the blade.
NOTE: If the lock nuts are damaged or worn replace them also.
3. Replace the carriage bolts and locknuts.

STORAGE

1. Wash any dirt or salt off the snow blower.
2. Remove drive chains and submerse in oil.
3. Smear grease over any exposed hydraulic cylinder shafts.

NUTS AND BOLTS

Check all nuts and bolts for tightness after the first 5 hours of operation then yearly.
Identifies special instructions or procedures that, if not strictly observed, could result in dam-
age to, or destruction of the machine, attachments or the environment.
SDX-117 11/22
© 2022 Alamo Group Inc.
MAINTENANCE
Maintenance Section 5-5