Driveline Attachment - Schulte SDX-117 Operator's Manual

Before operating the snow blower, carefully read the 'Safety' and 'Operation' sections of this
Operator's Manual.
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause death or
serious injury.
Never crawl under a raised Implement supported solely by the Tractor 3-Point hitch.
Release of the control lever or mechanical failure will result in the Implement falling and
possible injury or death. Always securely block up the Implement before crawling underneath
to perform repairs and service.

7.DRIVELINE ATTACHMENT

The driveline yoke and tractor PTO shaft must be
dirt free and greased for attachment.
Grease applied to PTO Shaft should meet the
following recommendations: Use EP 0, Lithium
Complex Grease
To connect the snow blower driveline to the
tractor, lift the PTO output shaft off of the PTO
holder A.
Twist the driveline yoke collar and align the
grooves and spines of the yoke with those of the
PTO shaft. Push the driveline yoke onto the PTO
shaft, release the locking collar, and position the
yoke until the locking collar balls are seated onto
the PTO shaft. Push and pull the driveline back
and forth several times to ensure a secure
attachment.
Lift the PTO holder, rotate and lower it into the in
service position
SDX-117 11/22
© 2022 Alamo Group Inc.
OPERATION
(SG-14)str
(S3PT-19) str
Operation Section 4-11