Table of Contents
Advertisement
Secure the Implement for transport before traveling on public roads.
Implements, secure the center axle using cylinder stops or transport pin and properly attach
a safety chain between the Implement and Tractor. Secure wings in upright position on
folding Implements using wing transport locks.
Transport only at speeds where you can maintain control of the equipment.
Serious accidents and injuries can result from operating this equipment at
high speeds. Understand the Tractor and Implement and how it handles
before transporting on streets and highways. Make sure the Tractor steering and brakes are
in good condition and operate properly.
Before transporting the Tractor and Implement, determine the proper transport speeds for
you and the equipment. Make sure you abide by the following rules:
Test the tractor at a slow speed and increase the speed slowly. Apply the Brakes smoothly
to determine the stopping characteristics of the Tractor and Implement. As you increase the
speed of the Tractor the stopping distance increases.
speed not to exceed 20 mph (30 kph) for transporting this equipment.
Test the equipment at a slow speed in turns. Increase the speed through the turn only after
you determine that the equipment can be operated at a higher speed. Use extreme care and
reduce your speed when turning sharply to prevent the tractor and implement from turning
over. Determine the maximum turning speed for you and this equipment before operating on
roads or uneven ground.
Only transport the Tractor and Implement at the speeds which allow you to properly control
the equipment.
Be aware of the operating conditions. Do not operate the Tractor with weak or faulty brakes
or worn tires. When operating down a hill or on wet or rain slick roads, the braking distance
increases: use extreme care and reduce your speed. When operating in traffic always use
the Tractor's flashing warning lights and reduce your speed. Be aware of traffic around you
and watch out for the other guy.
14.2 Hauling the Tractor and Snow Blower
Before
transporting
implement, measure the height and width
dimensions and gross weight of the complete
loaded unit. Ensure that the load will be in
compliance with the legal limits set for the areas
that will be traveled through. OPS-U- 0024str
SDX-117 11/22
© 2022 Alamo Group Inc.
OPERATION
(SG-19)str
a
loaded
tractor
and
Operation Section 4-35
(STI-7) str
Determine the maximum transport
For pull-type
Advertisement
Table of Contents
