Table of Contents
Advertisement
TRANSPORTING SAFETY INSTRUCTIONS AND PRACTICES
Be particularly careful when transporting the Implement with the Tractor. Turn curves or go
up hills only at a low speed and using a gradual steering angle. Rear mounted implements
move the center of gravity to the rear and remove weight from the front wheels.
certain, by adding front ballast, that at least 20% of the tractor's weight is on the front wheels
to prevent rearing up, loss of steering control or Tractor tip-over. Slow down on rough or
uneven surfaces to prevent loss of steering control which could result in property damage or
possible injury. Do not transport unless 3-Point lift lever is fully raised and in the latched
transport position. Dropping implement in transport can cause serious damage to the tractor
and/or Implement and possibly cause the operator or others to be killed or injured.
Allow sufficient clearance for the Implement to swing outward while turning. Implements
carried behind the Tractor will swing outside the tire path when making turns. Contacting a
solid object while turning will cause equipment damage and possible injury.
Make certain that the "Slow Moving Vehicle" (SMV) sign is installed in
such a way as to be clearly visible and legible. When transporting the
Equipment use the Tractor flashing warning lights and follow all local
traffic regulations.
Transport only at speeds where you can maintain control of the equipment.
Serious accidents and injuries can result from operating this equipment at
high speeds. Understand the Tractor and Implement and how it handles
before transporting on streets and highways. Make sure the Tractor steering and brakes are
in good condition and operate properly.
Before transporting the Tractor and Implement, determine the proper transport speeds for
you and the equipment. Make sure you abide by the following rules:
Test the tractor at a slow speed and increase the speed slowly. Apply the Brakes smoothly
to determine the stopping characteristics of the Tractor and Implement. As you increase the
speed of the Tractor the stopping distance increases.
speed not to exceed 20 mph (30 kph) for transporting this equipment.
Test the equipment at a slow speed in turns. Increase the speed through the turn only after
you determine that the equipment can be operated at a higher speed. Use extreme care and
reduce your speed when turning sharply to prevent the tractor and implement from turning
over. Determine the maximum turning speed for you and this equipment before operating on
roads or uneven ground.
Only transport the Tractor and Implement at the speeds which allow you to properly control
the equipment.
Be aware of the operating conditions. Do not operate the Tractor with weak or faulty brakes
or worn tires. When operating down a hill or on wet or rain slick roads, the braking distance
increases: use extreme care and reduce your speed. When operating in traffic always use
the Tractor's flashing warning lights and reduce your speed. Be aware of traffic around you
and watch out for the other guy.
Before transporting the Snow Blower, position the snow discharge chute in the center
position to reduce the possibility of blocking the operator's vision.
SDX-117 11/22
© 2022 Alamo Group Inc.
SAFETY
(SG-6)str
Determine the maximum transport
(SG-19)str
Safety Section 1-10
Make
(S3PT-02)str
(S3PT-20) str
(SSB-21) str
Advertisement
Table of Contents
