Table of Contents
Advertisement
GENERAL INFORMATION
(2) 3/16" x 1/2" Pop Rivet (Optional – Installer-Supplied)
3317114 .201 Wireless Receiver
• Receiver Wire Harness
• 3316518 .201 Remote Control
• Dry Contact Switch (Power)
3316519 .205 Vibration Sensor (Black)
Drill
#11 (0 .191") Drill Bit
Riveting Tool
Flat-Bladed Screwdriver/Bit (Small)
A. Receiver Control Range
L1 IN THE AIR
12 V
200 m (656 .17 ft)
INSTALLATION
ELECTRICAL SHOCK HAZARD . Disconnect 120 VAC power from RV . Failure to do so could result in death or
serious injury .
Failure to obey the following directions could result in damage to the unit or property:
• Install a 15 A fuse (installer supplied) at fuse panel for positive (+) 12 VDC power supply ( RED wire) to product .
• Disconnect the positive (+) 12 VDC terminal from supply battery .
• Disconnect power for ALL procedures under this section . Use a grommet (installer supplied) or equivalent protection when
routing wire through the RV's roof, floor, or walls.
A. Installing The Receiver
1 . Determine the receiver location, and then secure the receiver to the wall or cabinet using screws (installer supplied).
2 . Route the wiring .
If using dry contact switches, route the installer-supplied wiring inside the RV from the receiver location to the dry contact
switch installation site .
3 . Make the electrical connections according to the wiring diagram provided (FIG . 1) .
If this unit is being added to an existing awning with LEDs, the existing LED switch must be disconnected and
reconnected according to the wiring diagram provided (FIG. 1). If the existing LED switch is not disconnected, the LED will
not function .
REQUIRED HARDWARE
BASIC COMPONENTS
OPTIONAL COMPONENTS AND KITS
REQUIRED TOOLS
L2 WITH CONCRETE WALLS
35 m (114 .83 ft)
3
• Dry Contact Switch Wire Harness
• Miscellaneous Wire Connectors
3316519 .202 Vibration Sensor (White)
Phillips Screwdriver/Bit
7/16" Hex Nut Driver/Bit
Needle Nose Pliers
Wire Cutter
EMISSION FREQUENCY
433 .92 MHz
Advertisement
Table of Contents
