Programming The Vibration Sensor (If Applicable) - Dometic 9600017109 Installation & Operating Instructions Manual

INSTALLATION
C. Programming The Vibration Sensor (If Applicable)
Complete each programming step within four seconds of the previous step to keep the receiver in pairing mode . If the
receiver resets, restart the programming process.
• When installing a vibration sensor, complete the steps in "B. Programming The Remote Control" on page 4 then start
with STEP 1 of this procedure without delay .
STEP 1
Vibration Sensor
Front of
Sensor
Back of
Sensor
STEP 3
x2
Back of
Remote
Control
a . Press the P2 button once . The wireless receiver
beeps once and the awning jogs .
b . Press the P2 button a second time . The receiver
beeps once .
STEP 5
Vibration
Sensor Battery
Compartment
Sensor Base
Battery
Compartment
a.
x1 x1
b.
x1
Sensor Dial
Set to 5
STEP 2
Sensor Dial
STEP 4
Vibration
Sensor
Battery
Compartment
x1
a . Press the vibration sensor programming button . The
sensor beeps once, the wireless receiver beeps five
times, and the awning jogs.
STEP 6
x1
Programming
Button
a . Set the vibration sensor dial to the desired level of
detection (see Operation, "B. Adjusting The Vibration
Sensor (If Applicable)" on page 7) .
b . Press the vibration sensor programming button once .
The sensor beeps once, and the awning retracts.
5
Vibration Sensor
Battery Compartment
Set to 0
Programming
x1
Button
x5
The Awning
retracts.
x1
x1