General Information; Intended Use; Specifications - Dometic 9200 Series Installation Instructions Manual

General Information

NOTICE: Whenever heavy or prolonged rain or wind
is expected, or the awning is left unattended, it is
important to place the awning in the stowed (closed)
position. Damage as a result of weather is not covered
by the warranty.
NOTICE: Do not constrain or tie down the roller tube,
as this could disable the water shed feature—a feature
that automatically lowers one side of the awning during
light rain to allow water run off.
2 General Information
This section describes the included and optional parts
necessary to complete the installation process.
The images used in this document are for reference
purposes only. Components and component locations
may vary according to specific product models.
Measurements may vary ±0.38 in. (1.0 cm).
Included Parts
15 Amp Circuit Breaker
#14-10 x 1-1/2 in. Hex Head Screw
#6-20 x 7/16 in. Self-Drilling Hex
Head Washer Screw
Slic Pin
Hardware End Cover Kit
1
(3317080.000#)
1
The hardware end cover kit part number is appended with "B" for white,
.
or "U" for black
Optional Parts
1
Door Roller Kit
Back Channel Spacer Kit
RGB LED Controller
RGB LED RF Wireless Remote
Control Switch Accessory
1
Available as an accessory (not included)
4
Quantity
1
8
2
1
1
Reference Number
930004
3312853.025 (#)
3316969.017
3316969.025
3310455.062
.
Required Tools and Materials
Drill
3/16 in. Drill Bit
5/8 in. Drill Bit
7/32 in. Drill Bit (For Steel Mounting)
3/8 in. Hex Nut Driver (For Drill)
7/16 in. Hex Nut Driver (For Drill)
Sealant

3 Intended Use

This 9200 Series Power Awning (hereinafter referred to
as "Awning") is designed and intended for installation
on a Recreational Vehicle (hereinafter referred to as
"RV") during or after the RV manufacture. Use these
instructions to ensure correct installation and function of
the product.
The Product kit is available for order with various
components, so while some graphics may show different
components, they still illustrate the correct procedure.
All components that were not originally ordered can be
purchased as an add-on or upgrade.
The manufacturer accepts no liability for damage in the
following cases:
• Faulty assembly or connection
• Damage to the product resulting from mechanical
influences and excess voltage
• Alterations to the product without express permission
from the manufacturer
• Use for purposes other than those described in the
operating manual
Dometic Corporation reserves the right to modify
appearances and specifications without notice.

4 Specifications

This section describes the hardware dimensions
for 8962XX1.4X0#(L), 8962XX2.4X0#(L), and
8962XX3.4X0#(L) model back channels.
9200 Series Power Awning
EN