Table of Contents
Advertisement
INSTALLATION
FIG. 1
15 A Fused
Power Supply
LED Strip
(Optional)
Awning
Motor
Awning Switch
(Optional Installer Supplied)
(MOM-OFF-MOM)
FIRE OR ELECTRICAL SHOCK HAZARD. For all wire connections, use only NEC-approved connectors and
terminals that are appropriately sized for the wire gauge . Failure to do so could result in death or serious injury .
Failure to use NEC-approved connectors and terminals of the appropriate size could result in property damage .
B. Programming The Remote Control
Complete each programming step within four seconds of the previous step to keep the receiver in pairing mode . If the
receiver resets, restart the programming process.
• Disconnect all power to the receiver and wait at least ten seconds before beginning the programming process .
STEP 1
Back of Remote Control
STEP 3
Press the P2
button two times.
The Receiver
x2
beeps once after
each press of the
button.
Back of
Remote Control
IMPACT OR CRUSH HAZARD. Make sure the awning retract button and the awning extend button operate the
awning in the intended direction . Failure to obey this waring could result in death or serious injury .
• Refer to "A . The Function Of The Remote Control" on page 7 to test the remote control .
When STEP 4 is completed, proceed immediately to "C. Programming The Vibration Sensor (If Applicable)" on page 5.
Red
Black
Black
Red
Ignition
(Interlock)
Black
Retract
Green
Extend
Red
Remove Battery Cover
x2
15 A Inline Fuse
On/Off Switch
Optional LED Switch
(Installer Supplied)
Brown (-)
Blue (+)
Orange
Yellow
(Not Used)
STEP 2
12 VDC Power
Supply to Receiver
ON
STEP 4
Awning Retract
(Up) Button
Front of
Remote Control
4
Red (+)
Black (-)
Red (+)
White (-)
Receiver
RJ 11 Cable
Wireless Receiver
x1
When used on 9500
awning, press
button at Step 4 instead
of
x4
Down
Up button.
Advertisement
Table of Contents
