General Information; Tools And Materials; Preinstallation; Assembling The Awning - Dometic 944 07.00 Series Installation And Operation Manual

General Information

3 General Information
This section provides general information about the
awning and its components.
I The images used in this document are for reference
purposes only. Components and component
locations may vary according to specific product
models. Measurements may vary ±0.38 in. (10 mm).

3.1 Tools and Materials

Dometic recommends that the following tool be used
while installing the appliance.
Recommended Tools
Screwdriver

4 Preinstallation


CAUTION: LIFTING HAZARD.
Use proper lifting technique and control when
lifting this product. Failure to obey this caution
could result in personal injury.
I Start all screws into the holes before tightening the
nuts. Do not overtighten the nuts.
This section describes how to assemble the joiner tubes
and attach the awning fabric.
4

4.1 Assembling the Awning

t
1 Part Identification
Flat Washer
q
Locknut
w
Front Bars
e
1. Secure the front bars to the connector joints using the
provided screws, flat washers, and locknuts.
w
q
2 Inserting the Awning into the Front Bar
Groove (Side View)
q
Awning Fabric
w
2. Unroll the awning fabric on a flat, clean surface.
Trim Line Awning
e
w
q
r
Screw
r
Connector Joint
t
r
e
Groove in Front Bar
e
Rope
r
EN