Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
2)
Change the setting of [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (x page 29)
f Refer to "Navigating through the menu" (x page 55) for the operation of the menu screen.
3)
Press the <INPUT> button on the control panel or the input selection (<RGB1/2>, <DIGITAL LINK>,
<DVI-D>, <VIDEO>, <DisplayPort>, <HDMI>) buttons on the remote control to select the input.
4)
Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 36)
5)
Press the <SHIFT> button to adjust the position of the image.
6)
If the input signal is an RGB signal, press the <AUTO SETUP> button.
7)
Press the <ZOOM> button to adjust the size of the image to match the screen.
8)
Press the <FOCUS> button again to adjust the focus.
9)
Press the <ZOOM> button again to adjust the zoom and the size of the image to match the screen.
Note
f When the projector is switched on for the first time after purchase as well as when [ALL USER DATA] in the [PROJECTOR SETUP] menu →
[INITIALIZE] is executed, the focus adjustment screen is displayed after projection starts, then the initial setting screen is displayed. Refer to
"Start-up display" (x page 20) for details.
Switching off the projector
3)
1)
Press the power <v/b> button on the control panel or the power standby <v> button on the remote
control.
f The [POWER OFF(STANDBY)] confirmation screen is displayed.
2)
Press qw to select [OK], and press the <ENTER> button.
(Or press the power <v/b> button on the control panel or the power standby <v> button on the
remote control again.)
f Projection of the image will stop, and the power indicator <ON (G)/STANDBY (R)> on the projector body lights in orange. (The fan
keeps running.)
3)
Wait for about 100 seconds until the power indicator <ON (G)/STANDBY (R)> on the projector body
lights in red.
4)
Press the <OFF> side of the <MAIN POWER> switch to turn off the power.
Note
f Do not switch on the projector and project images immediately after switching off the projector.
Turning on the power while the lamp is still hot may shorten the lamp life.
f For about 75 seconds after the projector is switched off and the luminous lamp cooling is started, the lamp indicators will not light up even
if the power is switched on. Even after 75 seconds, the lamp may not light up if the projector is switched on. In such a case, after the power
indicator <ON (G)/STANDBY (R)> lights in red, switch on the projector again.
f The projector consumes power even when the power <v/b> button on the control panel or the power standby <v> button on the
remote control is pressed and the projector is switched off if the main power of the projector is on.
When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], use of some functions is restricted,
but the power consumption during standby can be conserved.
4)
1)
1)
2)
2)
ENGLISH - 45
Advertisement
Table of Contents
