Table of Contents
Advertisement
Setting [NO SIGNAL SHUT-OFF]
A function that automatically switches the power of the projector to standby if there is no input signal for a certain period of time. The time
before switching to standby can be set.
1)
Press as to select [ECO MANAGEMENT].
2)
Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3)
Press as to select [NO SIGNAL SHUT-OFF].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE]
[10MIN.] - [90MIN.]
Setting [STANDBY MODE]
Set the power consumption during the standby.
1)
Press as to select [ECO MANAGEMENT].
2)
Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3)
Press as to select [STANDBY MODE].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[ECO]
[NORMAL]
Note
f When [ECO] is set, the network function and some RS-232C commands become inoperable during standby. When [NORMAL] is set, the
network function becomes operable during standby.
f When set to [ECO], it may take approx. 10 seconds longer before the projector starts projecting after the power is turned on, compared with
when [NORMAL] is set.
f The [STANDBY MODE] settings are not reset to their factory defaults when [ALL USER DATA] in [PROJECTOR SETUP] menu →
[INITIALIZE] (x page 94) is executed.
[SCHEDULE]
Set the command execution schedule for each day of the week.
Enabling/disabling the schedule function
1)
Press as to select [SCHEDULE].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Note
f When [SCHEDULE] is set to [ON], the [STANDBY MODE] setting is forcibly switched to [NORMAL], and the setting cannot be changed.
Even if [SCHEDULE] is then set to [OFF] when in this state, the setting of [STANDBY MODE] remains at [NORMAL].
How to assign a program
1)
Press as to select [SCHEDULE].
86 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Disables the No signal shut-off function.
Allows you to set in ten minutes intervals.
Use this setting to reduce power consumption during standby.
Use this setting to use the network function during standby.
Disables the schedule function.
Enables the schedule function. Refer to "How to assign a program" (x page 86) or "How to set a
program" (x page 87) for how to set the schedule.
Advertisement
Table of Contents
