Table of Contents
Advertisement
3)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
[DAYLIGHT VIEW]
You can correct the image to the optimal vividness even if it is projected under a bright light.
1)
Press as to select [DAYLIGHT VIEW].
2)
Press qw or the <ENTER> button.
f The [DAYLIGHT VIEW] individual adjustment screen is displayed.
3)
Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
[OFF]
[1]
[2]
[3]
Note
f When [PROJECTION METHOD] (x page 84) is set to [REAR/FLOOR] or [REAR/CEILING], [AUTO] cannot be selected.
f When objects, etc. are placed on the top of the projector, the [AUTO] mode may not function properly.
[SYSTEM SELECTOR]
The projector will automatically detect the input signal, but you can set the system method manually when an unstable signal is input. Set the
system method matching the input signal.
1)
Press as to select [SYSTEM SELECTOR].
2)
Press the <ENTER> button.
3)
Press as to select a system format.
f Available system formats vary depending on the input signal.
Terminal
<VIDEO IN> terminal,
<VIDEO/G/Y>/<B/P
B
terminals
<RGB 1 IN> terminal, <RGB 2
IN> terminal
<DVI-D IN> terminal
<HDMI IN> terminal, <DIGITAL
LINK/LAN> terminal,
<DisplayPort IN> terminal
4)
Press the <ENTER> button.
Note
f Refer to "List of compatible signals" (x page 144) for the types of video signals that can be used with the projector.
f This may not function properly for some connected external devices.
64 - ENGLISH
Chapter 4 Settings — [PICTURE] menu
No correction.
Automatically corrects the aperture.
The brightness of the room is detected by the luminance sensor, and the vividness of the image is
automatically corrected.
No correction.
Corrects the image to weaken vividness.
Corrects the image to medium vividness.
Corrects the image to high vividness.
Select [AUTO], [NTSC], [NTSC4.43], [PAL], [PAL-M], [PAL-N], [SECAM], or [PAL60].
Set it to [AUTO] normally. (Setting [AUTO] will automatically select [NTSC], [NTSC4.43], [PAL],
/C>
[PAL-M], [PAL-N], [SECAM], or [PAL60].)
Switch the setting to the signal method for the TV used.
480i, 576i, or 576p signal
VGA60 or 480p signal
Other movie-based signals
480i, 576i, 480p, or 576p
signal
Other movie-based signals
480i, 576i, 480p, or 576p
signal
Other movie-based signals
System format
Select [RGB] or [YC
C
].
B
R
Select from [VGA60], [480p YC
Select [RGB] or [YP
P
].
B
R
Select [RGB] or [YC
C
].
B
R
Select [RGB] or [YP
P
].
B
R
Select [AUTO], [RGB], or [YC
C
B
Select [AUTO], [RGB], or [YP
P
B
C
], or [480p RGB].
B
R
].
R
].
R
Advertisement
Table of Contents
