Firmware Upgrade File Content And Location; Additional Upgrade Procedures; Table 11: File Content And Location After A Firmware Upgrade - Lantronix x6010 User Manual

Lantronix

Firmware Upgrade File Content and Location

The table below shows file content and location resulting from a firmware upgrade.

Table 11: File Content and Location after a Firmware Upgrade

File Type
Provisioning e.g.,
backup files '1-1-IONMM.config'
e.g.,
MIB 105con-
'agent3.conf'
figuration files
'ifMib.conf'

Additional Upgrade Procedures

Additional upgrade procedures are available for the ION system. Refer to the IONMM User Guide for
these IONMM upgrade procedures:
Upgrade the IONMM and/or NID Firmware.
•
Upgrade Slide-In and Remote Modules Firmware via TFTP. This procedure is used to upgrade
•
one or more of the slide-in modules installed in the ION Chassis or a remote module connected
to a slide-in module. Requires you to 1) Create Database Index and Archive Files, and 2) Perform
the Module Firmware Upgrade.
Perform the Module Firmware Upgrade – the upgrade consists of two parts: uploading the ar-
•
chive file to the IONMM, and then loading the upgrade file into the appropriate modules. This
procedure is for upgrading the ION system modules.
33493 Rev. F
Filename File Description
These files are only
used by provisioning
Restore
The MIB configura-
tion files for SNMP
setting
https://www.lantronix.com/
ION x6010 User Guide
Lost after
Firmware
Stored Directory
Upgrade?
/tftpboot Yes
/agent3/conf No
Page 105 of 261
(Y/N)