Table of Contents
Advertisement
Field
Secondary DNS Server
IP Address (optional)
Lan Interface Settings
Field
Current LAN interface
parameters
LAN interface speed
LAN interface duplex
mode
IPv6 Settings (Firmware v3.0 or higher)
Field
Enable IPv6
IPv6 address
IPv6 address dynamic
Link-local IPv6 address
Miscellaneous Network Settings
Field
Remote Console &
HTTPS port
HTTP port
TELNET port
SSH port
Bandwidth Limit
Enable TELNET/SSH
access
Spider™ and SpiderDuo® KVM-over-IP Device User Guide
Description
Enter the IP address of the Domain Name Server to be used if the Primary
DNS Server cannot be reached.
Description
Displays current LAN interface settings.
Manual setup may be required for older equipment. With autonegotiation on,
the window displays the current state of the link. Note that the parameters of
the second Ethernet port are not configurable, they remain at autonegotiate.
Select the speed from the drop-down menu.
Select the duplex mode from the drop-down menu.
Description
Select to enable IPv6.
IPv6 address displays when enable IPv6 is selected,
Assigned automatically by the system.
Network address intended only for communications within one segment of a
local network or a point-to-point link. Assigned automatically by the system.
Description
Port number at which the Spider device Remote Console server and HTTPS
server are listening. The default is 443.
Port number at which the Spider device's HTTP server is listening. The
default is 80.
Port number at which the Spider device's Telnet server is listening. The
default is 23.
Port number at which the Spider device's SSH server is listening. The
default is 22.
The maximum network traffic generated through the Spider device's primary
Ethernet port, in kilobits. If left blank, there is no bandwidth limitation applied.
For security, the default is having Telnet and SSH disabled. Check the
appropriate box (es) and set up the serial port for Telnet/SSH to use the
Telnet console.
7: Interfaces
58
Advertisement
Table of Contents
