Jumper Settings; Dip Switches; Figure 11: S6010 Dip Switches - Lantronix x6010 User Manual

Lantronix

Jumper Settings

The x6010 jumper settings are described below.
Jumper J8 – Configuration mode (HW / SW Mode): Jumper J8 defines the x6010 PCB's Hardware /
Software mode setting.
1-2: Hardware mode; the x6010 configuration is controlled by
•
hardware. Use the shorting plug to jumper (short) pins 1
and 2 for Hardware Mode.
2-3: Software mode; the x6010 configuration is controlled by
•
software (default). Use the shorting plug to jumper
(short) pins 2 and 3 for Software Mode.
The factory default setting is Software mode (pins 2 and 3 jumpered) as shown above. Note that in
Hardware mode you cannot make x6010 configuration changes from the Web interface, as the screen
fields are all grayed out. You can enter CLI commands with the x6010 in Hardware mode.
For more information, see

DIP Switches

Several multi-position DIP switches allow the network administrator to configure the x6010 for network
conditions. Use a small flat blade screwdriver or similar device to set these switches for site installation.
The x6010 DIP switches and jumpers are summarized below. The x6010 DIP switch settings are de-
scribed below. For more information, see
DIP Switch Locations
The S6010 DIP switch locations are shown below.
33493 Rev. F
"DIP Switches and Jumper
"DIP Switches and Jumper

Figure 11: S6010 DIP Switches

https://www.lantronix.com/
Settings".
Settings".
ION x6010 User Guide
Page 24 of 261