Arm; Count - HP E1361A 4X4 User Manual

Subsystem Syntax

:COUNt

Parameters
Comments
Example
:COUNt?
Parameters
Comments
42 Command Reference
All manuals and user guides at all-guides.com
The ARM subsystem selects the number of scanning cycles (1 to 32767) for each
command.
INITiate

ARM

number
:COUNt < > MIN | MAX
:COUNt? [MIN | MAX]
ARM:COUNt < number > MIN | MAX
times (1 to 32767) with one
is set. MIN sets 1 cycle and
Parameter Name
number
•
Number of Scans: Use only values between 1 and 32767 for the number of
scanning cycles.
•
Related Commands: ABORt
•
*RST Condition: ARM:COUNt 1
Setting Ten Scanning Cycles
This example sets a relay matrix for 10 scans of channels 00 through 03. When the
scan sequence completes, channels 00 through 03 (relays 00 through 03) are closed.
ARM COUN 10
SCAN (@100:103)
INIT
ARM:COUNt? [MIN | MAX]
. The current number of scan cycles is returned when
ARM:COUNt
not supplied. With or
MIN
32767.
Parameter Name
MIN | MAX
•
Related Commands: INITiate[:IMMediate]
allows scanning cycles to occur a multiple of
command when
INITiate
MAX sets 32767 cycles.
Parameter Type
numeric
, INITiate:IMMediate
Set 10 scans per INIT command
Scan channels 00-03
Start scan, close channel 00
returns the current number of scanning cycles set by
as a parameter,
MAX MIN
Parameter Type
numeric
ARM
INITiate:CONTinuous OFF | 0
Range of Values
1-32767 | MIN | MAX
or
MIN MAX
returns 1 and returns
MAX
Range of Values
MIN = 1, MAX = 32767
Chapter 5
is