Table of Contents
Advertisement
Subsystem Syntax
CLOSe
Parameters
Comments
Example
Chapter 5
All manuals and user guides at all-guides.com
The
command subsystem controls switching and scanning operations for
[ROUTe:]
relay matrix modules in a switchbox.
[ROUTe:]
channel_list
CLOSe <
channel_list
CLOSe? <
OPEN <
channel_list
OPEN? <
channel_list
channel_list
SCAN <
:MODE NONE | VOLT
:MODE?
channel_list
[ROUTe:]CLOSe <
channel_list. channel_list has the form (@nnrc) where nn = matrix card number
(01-99), r = matrix row number (0-3), and c = matrix column number (0-3).
Parameter Name
channel_list
•
Closing Channels:
To close a single channel, use
–
for multiple channels use
–
for sequential channels, use
–
for groups of sequential channels, use
–
[ROUTe:]CLOSe (@nnrc:nnrc,nnrc:nnrc)
or any combination.
–
Closure order for multiple channels with a single command is not guaranteed.
•
Related Commands:
[ROUTe:]OPEN
•
*RST Condition: All channels open
Closing Matrix Channels
This example closes channels 100 and 213 of a two-module switchbox
(card numbers 01 and 02).
CLOS (@100,213)
>
>
>
>
>
closes the relay matrix channels specified by
>
Parameter Type
numeric
[ROUTe:]CLOSe (@nnrc)
[ROUTe:]CLOSe (@nnrc,nnrc,...)
[ROUTe:]CLOSe (@nnrc:nnrc)
;
,
[ROUTe:]CLOSe?
Close channels 100 and 213. 100 closes
channel 00 of card #1 and 213 closes
channel 13 of card #2.
[ROUTe:]
Range of Values
nn00-nn03, nn10-nn13,
nn20-nn23, nn30-nn33
;
;
;
C ommand Reference49
Advertisement
Table of Contents
