Chapter 2, Configuring The Hp E1361A Relay Matrix; Using This Chapter; Warnings And Cautions - HP E1361A 4X4 User Manual

Configuring the HP E1361A Relay Matrix

Using This Chapter

Warnings and Cautions

Warning
Warning
Chapter 2
All manuals and user guides at all-guides.com
This chapter shows how to make user connections to the relay matrix and
some ways to configure the matrix module. Chapter contents are:
•
Warnings and Cautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 17
•
Connecting User Inputs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 18
•
Typical Matrix Configurations . . . . . . . . . . . . . . . . . . . . . . . Page 20
•
Changing Matrix Components. . . . . . . . . . . . . . . . . . . . . . . . Page 22
SHOCK HAZARD. Only qualified, service-trained personnel
who are aware of the hazards involved should install, configure,
or remove the relay matrix. Use only wire rated for the highest
input voltage and remove all power sources from the
mainframe and installed modules before installing or removing
a module.
CHANNEL WIRING INSULATION. All channels that have a
common connection must be insulated so that the user is
protected from electrical shock in the event that two or more
channels are connected together. This means wiring for all
channels must be insulated as though each channel carries the
voltage of the highest voltage channel.
Configuring the HP E1361A Relay Matrix 17
Chapter 2