Initiate; Continuous - HP E1361A 4X4 User Manual

Subsystem Syntax

:CONTinuous

Parameters
Comments
Example
46 Command Reference
All manuals and user guides at all-guides.com
The command subsystem selects continuous scanning cycles and starts the

INITiate

scanning cycle.
INITiate
mode
:CONTinuous <
:CONTinuous?
[:IMMediate]
mode
INITiate:CONTinuous <
the switchbox.
Parameter Name
mode
•
Continuous Scanning Operation: Continuous scanning is enabled with the
INITiate:CONTinuous ON
command closes the first channel in the channel list. Each
INITiate:IMMediate
trigger from a trigger source selected by the
advances the scan through the channel list. A trigger at the end of the channel list
closes the first channel in the channel list and the scan cycle repeats.
•
Non-Continuous Scanning Operation: Non-continuous scanning is enabled
with the
INITiate:CONTinuous OFF
Sending the INITiate:IMMediate
list. Each trigger from a trigger source selected by the
command advances the scan through the channel list. At the end of the scanning
cycle, the last channel in the channel list is closed.
•
Stopping Continuous Scan: See the
•
Related Commands:
ABORt
•
*RST Condition:
INITiate:CONTinuous OFF
Enabling Continuous Scanning
This example enables continuous scanning of channels 00 through 03 of a
single-module switchbox. Since
an interface clear command (such as CLEAR) to stop the scan.
INIT:CONT ON
SCAN (@100:103)
INIT
>
enables or disables continuous scanning cycles for
>
Parameter Type
boolean
or
INITiate:CONTinuous 1
TRIGger:SOURce
or
INITiate:CONTinuous 0
command closes the first channel in the channel
ABORt command.
, ,
ARM:COUNt TRIGger
TRIGger:SOURce IMMediate
Enable continuous scanning
Defines channel list
Start scan cycle, close channel 00
INITiate
Range of Values
ON | OFF | 1 | 0
command. Sending the
command
command.
TRIGger:SOURce
,
TRIGger:SOURce
(default) is set, use
Chapter 5