Before Use
Charging the Battery
Use only the charger and battery specified by Hytera. Charger
LED can indicate the charging process.
■
Charge Diagram
■
Procedures
1. Connect the power adapter to AC source. See arrow 1;
2. Plug the power adapter into the rear socket of the
charger. See arrow 2; (At this time, the LED glows green
to indicate the charger is ready for use.)
3. Place the radio with the battery attached, or the battery
alone, into the charger; See arrow 3;
4. The charging process initiates when LED glows red, and
is completed when LED glows green.
Note:To achieve optimal battery performance,
please charge the battery for 5 hours before initial
use.
■
Charge Indicator
LED Indicator
LED solidly glows red.
LED solidly glows orange.
LED solidly glows green.
When battery power runs low, the LED will flash red, and the
low-pitched tone will sound periodically. In this case, please
replace or charge the battery.
Caution: Be sure to read the Safety Information
Booklet, to get necessary safety information.
TC- 446S
TC- 446S
Charge Status
Charging
About fully charged
Fully charged
Ready for use
5