Hytera TC- 446S Manual page 3

or distributed in any manner without the express written
permission of Hytera.
If you have any suggestions or would like to learn more
details, please visit our website at: http://www.hytera.cn.
RF Energy Exposure Compliance
Your product is designed and tested to comply with a number
of national and international standards and guidelines
(listed below) regarding human exposure to radio frequency
electromagnetic energy. This product complies with the IEEE
and ICNIRP exposure limits for occupational/controlled RF
exposure environment at operating duty factors of up to 50%
transmitting and is authorized by the FCC for occupational
use only. In terms of measuring RF energy for compliance
with the FCC exposure guidelines, your product radiates
measurable RF energy only while it is transmitting (during
talking), not when it is receiving (listening) or in standby mode.
Your product complies with the following of RF energy
exposure standards and guidelines
●
United States Federal Communications Commission,
Code of Federal Regulations; 47CFR part 2 sub-part J
●
American National Standards Institute (ANSI)/Institute of
Electrical and Electronic Engineers (IEEE) C95. 1-1992
●
Institute of Electrical and Electronic Engineers (IEEE)
C95. 1-1999 Edition
● International Commission on Non-Ionizing Radiation
Protection (ICNIRP) 1998
Operational Instructions and Training Guidelines
To ensure optimal performance and compliance with the
occupational/controlled environment RF energy exposure
limits in the above standards and guidelines, users should
transmit no more than 50% of the time and always adhere to
the following procedures:
Transmit and Receive
To transmit (talk), push the Push-To-Talk (PTT) key; to
receive, release the PTT key.
FCC Licensing Information
Part 15 Compliance
This product has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This product generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this product does cause harmful interference
TC- 446S TC- 446S
3