Installing Software On The Ni-9147 - National Instruments NI-9147 Getting Started

3. Click the Security Configuration icon.
4. Click Login.
5. In the Login dialog box, enter the username admin and leave the password
field blank.
6. Click OK.
7. Click Change Password.
8. Enter and re-enter a new password.
9. Click OK.
10. Click Save.
11. Click OK to confirm you are changing the password.
Caution
password, you must contact NI and reformat the controller.

Installing Software on the NI-9147

Complete the following steps to install software on the NI-9147.
1. In MAX, expand your system under Remote Systems.
2. Right-click Software.
3. Select Add/Remove Software to launch the LabVIEW Real-Time Software
Wizard.
Tip
You must log in if you set a system password.
4. Select the recommended software set for your LabVIEW and NI-RIO Device
Drivers versions.
5. Click Next.
6. Select NI Scan Engine from the software add-ons.
Select any additional software to install. If you plan on using the NI-9147 with
the LabVIEW FPGA Module, you can click Next. Click NI Scan Engine if you plan
on using the NI-9147 without the LabVIEW FPGA Module.
NI cannot recover lost system passwords. If you forget the
NI-9147 Getting Started
© National Instruments
13