Table of Contents
Advertisement
MONITORING SOLUTION ENERGY
TEMPERATURE SENSORS
The following picture shows the temperature sensor configuration section in antenna pair.
:
:
:
:
:
:
:
Modbus addresses are assigned to sensors following order of configuration. In case of you need
respect a specific Modbus mapping, please take care of the order while you add sensors to the
antenna pair.
Check status
The Check button, will perform an interrogation of the sensor. This operation could take up to 20
seconds. Check status Led indicates if sensor installation permit correct interrogation by the reader.
:
:
:
:
AMS01 Configuration Tool User Manual
www.senseor.com
Add sensor(s) by selecting XML file(s) into the antenna pair.
Name of the sensor (max 19 digits).
Check the sensor.
Enter the reference temperature (only available when Individual reference
temperature use is selected in Temperature installation settings space).
Open diagnostic window (see next section – only available when check has
been made).
Select a temperature Notifier to associate with the sensor (see
monitoring
notifiers' chapter).
Remove the sensor from the antenna pair.
No check has been performed.
The sensor does not meet measurement criteria and cannot be commissioned.
The sensor does not meet minimal measurement criteria and requires manual
commissioning.
The sensor meets all measurement criteria and is automatically commissioned
by the system.
'Temperature
17/29
Advertisement
Table of Contents
