Table of Contents
Advertisement
MONITORING SOLUTION ENERGY
READER WINDOW DESCRIPTION
SETTINGS TAB
This tab shows the reader information and could be used to configure the following settings:
-
READER NAME (max 19 digits)
-
SYSTEM
•
Mains power frequency ('50 Hz' or '60 Hz')
•
System temperature unit (Celsius or Fahrenheit)
•
Compatibility mode selection ('AMS01' or 'HTR02')
-
ETHERNET
•
IP address (IPv4 format)
•
Subnet mask (IPv4 format)
•
Default gateway (IPv4 format)
-
RS485 MODBUS (RTU)
•
Modbus address (from '1' to '247' – default value is printed on the reader label)
•
Speed (default value is '19 200' bauds)
•
Parity (default value is 'None')
•
Stop bits (default value is '1')
-
TIME ZONE
1
Select the mains frequency of the measured electric system depending of your installation region (incorrect
selection could result in no detection of partial discharge).
2
Selecting HTR02 compatibility mode results in limitation of reader capacity as only antenna pairs 1 to 3. A
maximum of 6 sensors per antenna pairs are available for measurement. Compatibility mode could be used in
case of addition / replacement of existing HTR02 systems in order to keep the same Modbus table interface.
AMS01 Configuration Tool User Manual
www.senseor.com
1
2
12/29
Advertisement
Table of Contents
