Ricoh AP600N Setup Manual page 48

Installing Options
F F F F
While aligning the power cord to
the left side groove of the Duplex
Unit, slide the Duplex Unit in un-
til it is connected to the printer.
2
G G G G
Attach the interface cable to the
printer.
H H H H
Plug the printer's power cord
back into the wall outlet, and then
turn on the power switch.
Note
❒ After installing the last option
that you want, print the config-
uration page to confirm the in-
stallation. If the new device is
listed in the column of configu-
ration options, then it has been
properly installed. For more in-
formation about printing the
configuration page, see "Print-
ing the Configuration Page" in the
Printer Reference on the CD-
ROM labeled "Operating In-
structions".
44
❒ If the Duplex unit is not in-
stalled properly, repeat the pro-
cedure from step
cannot install it properly even
after reinstallation, contact your
sales or service representative.
❒ If the printing position is not
correct, adjust the registration
of the trays. For more informa-
tion about adjusting the regis-
t r a t i o n o f t h e t r a y s , s e e
"Adjusting the Registration of
the Trays" in the Printer Refer-
ence.
ZKGX231E
ZKGX240E
B
. If you