Ricoh AP600N Setup Manual page 27

R CAUTION:
• When lifting the machine, use
the inset grips on both sides.
Otherwise the printer could
break or cause injury if dropped.
E E E E
Attach the interface cable to the
printer.
F F F F
Plug the printer's power cord
back into the wall outlet, and then
turn on the power switch.
Note
❒ After installing the last option
that you want, print the config-
uration page to confirm the in-
stallation. If the new device is
listed in the column of configu-
ration options, then it has been
properly installed. For more in-
formation about printing the
configuration page, see "Print-
ing the Configuration Page" in the
Printer Reference on the CD-
ROM labeled "Operating In-
structions".
❒ If the Paper feed unit is not in-
stalled properly, repeat the pro-
cedure from step
cannot install it properly even
after reinstallation, contact your
sales or service representative.
ZKGH052E
B
. If you
Paper Feed Unit Type 600
Reference
For information about loading
paper, see "Loading Paper in the
Optional Paper Tray" in the
Printer Reference on the CD-
ROM labeled "Operating In-
structions".
If the printing position is not
correct, adjust the registration
of the trays. For more informa-
tion about adjusting the regis-
t r a t i o n o f t h e t r a y s , s e e
"Adjusting the Registration of
the Trays" in the Printer Refer-
ence.
2
23