Editing A Route - Raymarine RC400 Owner's Handbook Manual

Chapter 5: Operation

Editing a Route

A route may be edited in order to:
•
•
•
•
Any changes made to the route affect only the current route, so the route
must be saved in order to keep the changes.
Inserting/Deleting Waypoints in a Route
➤
To add waypoint(s) to the end of a route:
Note: If no current route is displayed, select a route from the Route List
and use the SHOW ROUTE function to make it active, see Retrieving a
route from the database.
1. Select ROUTES then EDIT ROUTE and press ENTER; the PLACE WAY-
2. Add waypoint(s) to the route by moving the cursor and pressing
3. Remove waypoints from a route by pressing CLEAR in the same way
4. When your changes are complete, press and release the GOTO/MOB
5. Press CLEAR twice to return to chart mode.
Note: When deleting waypoints, if the route has not been saved, the way-
point is erased. If the route has been saved, the waypoint remains on the
screen.
➤
To insert a waypoint into a route:
1. Move the cursor over the route leg where a waypoint is to be inserted.
Add a Waypoint into a route
Remove a Waypoint from a route
Move a Waypoint (as described in Section 5.2)
Reverse a Route
POINT function is displayed.
ENTER in the same way as the route was first created.
as the route was first created.
key to end route editing.
The route leg data is shown in the status bar and the ROUTE OPTIONS
function, with help text, is displayed:
63