Preparing The M16C R8C Fousb/Uart Debugger - Renesas M16C R8C UART Debugger User Manual

2. Preparing the M16C R8C FoUSB/UART Debugger

The M16C R8C FoUSB/UART debugger (hereinafter R8C UART debugger) is used for
debugging by connecting an RS-232C cable between the host computer and the target
board.
A monitor program comes bundled and is automatically installed with the R8C UART
debugger software.
For the R8C Family, the monitor program is automatically programmed when starting the
R8C UART debugger. The monitor program does not need to be preprogrammed with an
M16C FlashStarter or other flash programmer.
Note: Before using the R8C UART debugger for the R8C/Mx Series, erase the user
area using a serial writer such as Flash Development Toolkit in advance.
a) To start the High-performance Embedded Workshop, go to "Start", "Programs",
"Renesas", "High-performance Embedded Workshop", and "High-performance
Embedded Workshop". You will see the following "Welcome!" dialog box.
- "Create a new project work space"
Select this when creating a new workspace.
- "Open a recent project workspace"
Select this when using an existing workspace. Previous workspaces are displayed in the
pull-down menu.
- "Browse to another project workspace"
Select this when using an existing workspace, and there are no previous workspaces
listed in the pull-down menu.
After selecting an existing workspace and pressing [OK], the screen shown in letter t) (Page 21)
is displayed.
7