Toyota RAV4 2019 Owner's Manual page 71

WARNING
■
The information display at low
temperatures
Allow the interior of the vehicle to
warm up before using the liquid crys-
tal information display. At extremely
low temperatures, the display moni-
tor may respond slowly, and display
changes may be delayed.
For example, there is a lag between
the driver's shifting and the new gear
number appearing on the display.
This lag could cause the driver to
downshift again, causing rapid and
excessive engine braking and possi-
bly an accident resulting in death or
injury.
NOTICE
■
To prevent damage to the engine
and its components
●
Do not let the indicator needle of
the tachometer enter the red zone,
which indicates the maximum
engine speed.
●
The engine may be overheating if
the engine coolant temperature
gauge is in the red zone ("H"). In
this case, immediately stop the
vehicle in a safe place, and check
the engine after it has cooled com-
pletely. (P.395)
Using the "ODO TRIP"
switch
Switches the items of the odometer,
trip meter A, trip meter B and the
brightness of the instrument cluster
lights by pressing the "ODO TRIP"
switch.
 When the trip meter is displayed,
pressing and holding the switch
will reset the trip meter.
2-1. Instrument cluster
 When the instrument cluster light
control display is displayed,
pressing and holding the switch
will adjust the brightness of the
instrument cluster lights.
■
Instrument cluster brightness
adjustment
The instrument cluster brightness levels
when the tail lights are on and off can be
adjusted individually. However, when
the surroundings are bright (daytime,
etc.), turning on the tail lights will not
change the instrument cluster bright-
ness.
Adjusting the clock
The clocks can be adjusted on the
audio system screen.
Refer to "Navigation and Multime-
dia System Owner's Manual" or
"Multimedia Owner's Manual".
69
2