234
4-5. Using the driving support systems
1
Increases the speed
2
Decreases the speed
Fine adjustment: Press the switch.
Large adjustment: Press and hold the
switch to change the speed, and
release when the desired speed is
reached.
The set speed will be increased or
decreased as follows:
Fine adjustment: By 1 km/h (0.6
mph) each time the switch is oper-
ated.
Large adjustment: The set speed
can be increased or decreased
continually until the switch is
released.
Canceling and resuming the
constant speed control
1
Pressing the cancel switch can-
cels the constant speed control.
The speed setting is also canceled
when the brakes are applied or the
clutch pedal (manual transmission only)
is depressed.
2
Pressing the "+ RES" switch
resumes the constant speed
control.
Resuming is available when the vehicle
speed is more than approximately 30
km/h (20 mph).
■
Cruise control can be set when
●
The shift lever is in D.
●
Vehicle speed is above approximately
30 km/h (20 mph).
■
Accelerating after setting the vehi-
cle speed
●
The vehicle can be accelerated nor-
mally. After acceleration, the set
speed resumes.
●
Even without canceling the cruise
control, the set speed can be
increased by first accelerating the
vehicle to the desired speed and then
pushing the "- SET" switch to set the
new speed.
■
Automatic cancelation of cruise
control
Cruise control will stop maintaining the
vehicle speed in any of the following sit-
uations.
●
Actual vehicle speed falls more than
approximately 16 km/h (10 mph)
below the preset vehicle speed.
●
Actual vehicle speed is below approxi-
mately 30 km/h (20 mph).
●
VSC is activated.
●
TRC is activated for a period of time.
●
When the VSC or TRC system is
turned off.
■
If the warning message for the
cruise control is shown on the
multi-information display
Press the cruise control main switch