Selecting Sonar Mode - Raymarine DSM250 Owner's Handbook Manual

Chapter 3: Getting Started
➤
MENU
SONAR
SET UP¬

3.5 Selecting Sonar Mode

➤
DISPLAY
However, if your repeater display is a PLUS fishfinder, you must
tell the unit to be a repeater.
To set the fishfinder display to be the sonar repeater:
1. Press the MENU key.
The Menu soft keys appear.
2. Press the SONAR SET UP soft key.
The Sonar Set Up menu appears.
3. Press the trackpad until the SONAR HSB MODE parameter is high-
lighted (selected).
4. Press the REPEATER soft key.
5. Press ENTER.
The display unit is now designated as the Repeater.
Full details on setting up your DSM250 and display are given in
Chapter 4.
If properly connected to an
Fishfinder display unit, you can begin viewing echo sounder data
by setting the display to Sonar mode.
Note: Data, such as depth, speed, temperature, log, and trip are still
available even if Sonar mode is not selected.
To set the mode, press the DISPLAY key to show the DISPLAY pop-up,
then press again to cycle through the modes available, shown in
Figure 3-1 .
PLUS Radar, Chartplotter, or
hsb
2
3-3