Table of Contents
Advertisement
Unpacking the DSC 6000
The DSC 6000 System consists of the following components:
DSC 6000
•
•
Personal Computer
•
Pyris Software
•
Printer (optional)
CryoFill Liquid Nitrogen System (optional)
•
Intracooler 6P (optional)
•
Chiller (optional)
•
•
Autosampler (optional)
The CryoFill LN2 System is an optional cooling system which allows the DSC 6000 to run in
subambient mode, at temperatures down to –170 °C.
The autosampler is an optional accessory that is used to automate the running of multiple
samples. The sample tray holds up to 45 samples. Runs can be sequenced and postrun data
analyzed by using a play list which is created using the Pyris Player software.
Unpacking the DSC 6000
The DSC 6000 comes wrapped in plastic and is surrounded by foam on all sides of the
analyzer. The DSC 6000 weighs 17 kg (37 lb), or 19 kg (42 lb) with the autosampler
installed. To unpack the analyzer, follow the steps below:
1. Remove the foam inserts from the box.
2. Remove the analyzer from the box.
3. Remove the foam from all sides, turning the analyzer on end as necessary.
4. Remove the tape and plastic from around the analyzer.
5. Remove the tape from the outer furnace lid and remove the lid. Place it to the side.
6. Remove the packing material from inside the furnace area.
7. Remove the tape from the connectors on the rear of the instrument.
When unpacking each box of your shipment, check all the parts included against the shipping
list. If any part is damaged or missing, contact the delivery service and PerkinElmer
immediately.
The DSC 6000 is shipped with a Spares Kit. If you have purchased the AS 600 Autosampler,
this is installed at the factory.
Install a DSC 6000 . 37
Advertisement
Table of Contents
