Table of Contents
Advertisement
6. Special procedures
6.1 – User parameters factory reset
If necessary it is possible to revert all internal parameter to their original factory
This procedure will rewrite all user and internal backup memory, restoring
values.
all parameters to their factory defaults. The procedure is irreversible.
NOTE: For restoring factory default values for a specific product/setup or system
parameters, access menu Utility and use option Restore prod. default config or
Restore system default config.
To revert all equipment parameters to factory default:
1.
Turn off the equipment;
2.
Keep key
After few seconds the message Flash INIT will appear. Wait until it is complete.
3.
Do not interrupt.
After completion the equipment will boot up normally and will be ready for use.
40
pressed and turn the equipment back on;
M20-EPS User Guide
Advertisement
Table of Contents
