Table of Contents
Advertisement
2. Equipment placement and safety information
2.1 – Instruction and site selection
The Metrolog M20-EPS fusion tester has a robust case, designed for continuous floor
shop use; however, some simple guidelines should be followed to reduce maintenances:
• Place the equipment base over a flat and leveled surface.
• Avoid places with Strong vibration.
• Keep it away from liquids and strong magnetic fields.
• If possible secure the equipment base over the working bench (use available holes on
the base, as shown in Picture 2).
• Attach the solenoid valves cable to the upper back connector, as shown in Picture 3,
highlight A.
• Connect the equipment to a power outlet using the supplied power cord, as shown in
Picture 3, highlight B. The M20-EPS accept power supply from 90~240V
sinusoidal, without any additional setup. Make sure the ground connection is properly
connected to the power cord center pin.
Picture 2 – Securing equipment on
working bench
IMPORTANT NOTE:
Special care must be taken before connecting the equipment to external
devices. Always use shielded cabled and EMI suppressor no minimize
interferences.
Metrolog Controles de Medição Ltda
Picture 3 – Solenoid valves cable
connection and power cord connection.
, 50~60Hz
AC
11
Advertisement
Table of Contents
