2.3 – AG20 measurement needle installation
To install or replace the AG20-20 or AG20-50 needle, follow the steps
•
Unpacking the AG20 needle, keeping protective cap;
Connect the supplied hose to the AG20 quick fitting;
•
•
Connect the other hose end to the M20-EPS Measurement needle connection
port, as highlighted below as D;
Remove the AG20 cover cap with care and place the needle in the resting pad,
•
as highlighted below as E;
Please note the quick fit connection highlighted below as C is intended for the
•
compressed air supply
Review the safety guidelines on this document before use.
•
The installation of the long needles (AG20-100 to AG20-1000) should be done
in a similar way. Check the safety and usage guidelines for long needles in sections 2.4
– Safety guidelines while using the AG20 and 3.4 – Deep Measuring before starting to
use them.
Metrolog Controles de Medição Ltda
Picture 6 – Installing AG20 measurement needle
13