Section 11 - Troubleshooting - Mec 1330SE Operator's Manual

Section 11 - Troubleshooting

Machine functions will not operate
• Master disconnect turned on?
• Batteries properly connected?
• Batteries fully charged?
• Key Switch in proper position?
• Both Emergency Stop Switches reset?
• Function Enable Switch not activated?
Hydraulic fluid level low?
•
Obvious fluid leak or damaged component?
•
• Wires disconnected, broken, or loose?
• Diagnostic panel on?
• Platform Control Box Fault Code present?
• Refer to service manual or contact MEC Technical Support.
Page 36
Troubleshooting Troubleshooting
Should you experience erratic operation or notice any malfunction while
operating this machine, discontinue use immediately.
Call for assistance and report the incident to your supervisor, and do
not use the machine until it has been checked by a trained, qualified
mechanic.
1330SE - Operator's Manual
June 2023