Table of Contents
Advertisement
AUTODOME IP starlight 5100i IR
1.1
Additional tools required
The table that follows is a list of additional tools (not supplied by Bosch) required to install an
AUTODOME camera or its accessories:
Quantity
1 roll
1 tube
--
1.2
System requirements
Our recommendations are:
–
–
–
–
–
1.3
Establishing the connection
The unit must have a valid IP address and a compatible subnet mask to operate on your
network. By default, DHCP is pre-set at the factory to On and so your DHCP server assigns an
IP address. With no DHCP server the default address is 192.168.0.1
The Project Assistant app or Configuration Manager (version 7.50 or higher) can be used to
find the IP address. Download the software from https://downloadstore.boschsecurity.com:
1.
2.
3.
IP cameras from Bosch have many ways to connect.
The core communication protocol is called RCP+ (Remote Control Protocol plus), which
handles the connections between camera and connected clients.
Every camera can handle a maximum of 128 RCP+ connections, from which a few are used
internally, making 100+ external RCP+ connections possible for unicast, multi-unicast, or
multicast connections.
A video connection also requires one or two such connections, depending on the access
method. Assuming the accumulated requested bitrate does not exceed the available network
interface bandwidth, a minimum of five unicast connections is possible.
Project Assistant
In order to use this device with the Project Assistant app by Bosch, you must download the
app from the Bosch Download Store, from Google Play, or from the Apple Store.
You can access the app in several ways:
–
Bosch Security Systems
Tool
Teflon tape
Weatherproof sealant, neutral cure type, electronic grade
Appropriate fasteners (of corrosion-resistant stainless steel with a
diameter of 10 mm (3/8 in.)), and anchors as necessary, dependent on
the surface to which the mount is attached
Computer with Dual core HyperThreading processor or better
Graphic card with performance that matches or is better than the resolution of the
camera
Windows 10 or later
Network access
Google Chrome, Microsoft Edge, or Mozilla Firefox
- or -
Application software, for example, Video Security Client, Bosch Video Client or BVMS.
Start the web browser.
Enter the IP address of the device as the URL.
During the initial installation, confirm any security questions that show.
Scan the QR code from the QIG.
User Manual
Introduction | en
7
2023-01 | 1.2 |
Advertisement
Table of Contents
