Pre-Positions And Tours - Bosch NDP-5523-Z30L User Manual

AUTODOME IP starlight 5100i IR
1.
2.
3.
4.
5.
Note: Tour B is now intended for use with the 'IVA while moving' functions.
You must first calibrate the camera to North before the camera displays accurate compass
headings. The camera uses this calibration, usually set to magnetic North, as the zero degree
pan position and as the North compass heading. The camera then displays the compass
heading based on the number of degrees from the North calibration point.
To set the North calibration point:
1.
2.
3.
North point
–
–
Alternative home position
Click Set to set the alternative home position for the camera.
Click Clear to clear the alternative home position.
6.11

Pre-positions and Tours

The camera can store up to 256 preset scenes. You can define the individual scenes that
comprise a Pre-position Tour.
You define individual pre-position scenes, then use these scenes to define the Pre-position
Tour. The tour starts from the lowest scene number in the tour and progresses sequentially to
the highest scene number in the tour. The tour displays each scene for a specified dwell time
before advancing to the next scene.
By default, all scenes are part of the Pre-position Tour unless removed.
To define and edit an individual pre-position:
1.
2.
3.
4.
5.
6.
7.
Bosch Security Systems
Click the Start Recording button. The system prompts you to overwrite the existing tour.
Click Yes to overwrite the existing tour movements.
Click the View Control link, under the image cameo, to access the directional and zoom
controls.
Use the View Control dialog box to make the necessary camera movements.
Click the Stop Recording button to save all actions.
Determine the North compass heading, then move the camera to that position.
Select the radio button On for the parameter Compass.
Click the button next to North point to set the calibration point.
Click the Set button to overwrite the existing North point. A dialog box appears with the
message, "Overwrite North point?" To confirm, click OK. To cancel, click Cancel.
Click the Clear button to reset the North point to factory defaults. A dialog box appears
with the message, "Reset North point to factory defaults?" To confirm, click OK. To
cancel, click Cancel.
Set the pre-position in the video image.
– Use the PTZ controls to move the camera into position.
– Using the Live preview window as reference, navigate to the scene that you want to
define as a pre-position.
Click the button Add pre-position ("+") to define the pre-position.
Select a number for the pre-position, from 1 to 256.
Type an optional name for the pre-position, up to 20 characters long.
Click OK to save the pre-position to the list Pre-positions.
To include the pre-position in a standard tour, select the check box to the left of the field
"Include in standard tour (marked with *)." An asterisk (*) appears to the left of the
name in the list Pre-positions.
For IR cameras only: To add IR light to the pre-position, select the check box to the left of
the field "IR light (marked with #)".
User Manual
Camera | en 37
2023-01 | 1.2 |