SMA DATA MANAGER M Operating Manual page 30

6 Connection
☐ Connection cable
Requirements:
☐ The signal source must be technically suitable for connection to the digital inputs (see
Section 12, page 63).
☐ The connected digital signal source has a safe separation to the grid potential. When
connecting the digital signal source the potential-free contact or an external potential-free
contact is used.
☐ The connection cable must be prepared for connection to the multipole terminal block (see
Section 6.2, page 29).
Overview:
Figure 6: Pin assignment
Pin
1
2
3
4
5
6
1)
With the fast-stop function, depending on the set inverter operating mode, inverters can be
disconnected from the utility grid or enter into standby operation. For further information on SMA
products with fast-stop function see manual of the SMA products.
30 EDMM-10-BE-en-27
Pin assignment
DI1
DI2
DI3
DI4
DI5
24 V
3 3 4 4 2 2
6 6 1 1 5 5
Explanation
Digital input
Digital input
Digital input
Digital input
1)
Fast stop
Voltage supply output
SMA Solar Technology AG
Operating manual