Table of Contents
Advertisement
WARNING! THIS APPLIANCE MUST BE GROUNDED
The electrical safety of this appliance can only be guaranteed when continuity is complete between it and an effective
earthing system, which complies with current local and national safety regulations.
You can access terminal block at the bottom of the appliance. Open terminal block with the use of a screwdriver with a
slotted tip. Make electrical connection as shown in the table above, depending on the model purchased and the type of
electrical connection.
Basic adaptation of environment sensors
After each connection to electrical network, basic adaptation is automatically performed which ensures the optimal
function of the sensors. All displays light up for a few seconds. During sensor adaptation, there must be no objects. If not,
the adaptation stops until you remove the objects. During this time you cannot use the cooking panel.
technical customer documentation
company: 0083 / E.G.O. Germany (E.G.O. Elektro-Gerätebau GmbH)
4.2.9
Power level display
Dependent of the status of the pot, the pot shape is changing its color.
Power level 0:
technical customer documentation
Power level 1 to 3.5:
Pot Programs:
company: 0083 / E.G.O. Germany (E.G.O. Elektro-Gerätebau GmbH)
Power level 4 to 6.5:
Power level 7 to B:
Lifted pot:
4.2.8
Power levels
In general, there are 18 power levels implemented in the power level slider.
[0, 1, 1.5, 2, 2.5, 3, 3.5, 4, 4.5, 5, 5.5, 6, 6.5, 7, 7.5, 8, 8.5, 9]
If a pot is selected, the display shows only full power level 0 on the slider. As soon as the user set po
level >0 a dot is displayed on the left and right side of the level to indicate half power levels.
The user can select half step power values by doing the following:
Select a half power level by touching between the power values shown in the slider
Pot is displayed in blue
Pot is displayed in purple
Pot is displayed in purple
Pot is displayed in red
Pot is displayed in orange
Pot is displayed in grey
26
6
1
2
3
4
5
Advertisement
Table of Contents
