Dear clients, Thank you for having chosen our induction ceramic hob. In order to make the best use of your appliance, we would advise you to read carefully the following notes and to keep them for a later consulting. SUMMARY SAFETY............................
SAFETY Precautions before using Unpack all the materials. The installation and connecting of the appliance have to be done by approved specialists. The manufacturer can not be responsible for damage caused by building-in or connecting errors. To be used, the appliance must be well-equipped and installed in a kitchen unit and an adapted and approved work surface.
Precautions not to damage the appliance Raw pan bottoms or damaged saucepans (not enamelled cast iron pots,) may damage the ceramic glass. Sand or other abrasive materials may damage ceramic glass. Avoid dropping objects, even little ones, on the vitroceramic. ...
DESCRIPTION OF THE APPLIANCE Technical characteristics Position of the Nominal Booster Type Total Power Diameter heating zone Power* Power* Front left 2000 W 2300 W 200 mm 6000 W Rear left 1200 W 1400 W 180 mm 7331230 Right 2000 W 2300 W 250 mm Front left...
USE OF THE APPLIANCE Display Display Designation Function Zero The heating zone is activated. 1…9 Power level Selection of the cooking level. Pan detection No pan or inadequate pan. Heat accelerator Automatic cooking. Error message Electronic failure. Residual heat The heating zone is hot. Booster The boosted power is activated.
Starting-up You must first switching on the hob, then the heating zone : Start-up/ switch off the hob : Action Control panel Display To start Press key [ 3 or 4 x [ 0 ] Touch the key Press key [ Nothing or [ H ] ...
Booster function The booster function [ B ] grants a boost of power to the selected heating zone. If this function is activated the heating zones works during 10 minutes with an ultra high power. The booster is foreseen for example to heat up rapidly big quantities of water, like for noodles cooking.
To stop the cooking time : Action Control panel Display Zone selection Press key [ + ] from the zone [ 0 ] To select « Timer » Press key [ The remaining time To stop the « Timer » Press key [ - ] and [ [ 00 ] then stops simultaneously...
Control panel locking To avoid modifying a setting of cooking zones , in particular with within the framework of cleaning the control panel can be locked (with exception to the On/Off key [ Locking : Action Control panel Display Start Press key [ 3 or 4 x [ 0 ] or [ H ]...
WHAT TO DO IN CASE OF A PROBLEM The symbol [ E 4 ] displays : The hob must be configured according to the following procedure. I) Warning : before starting all pots must be removed from the cooktop. II) Disconnect the cooktop from the main supply : remove fuse or disconnect circuit breaker.
The control panel displays [ C ] or [ E ] : Call the After-sales Service. One or all cooking zone cut-off : The safety system functioned. You forgot to cut-off the cooking zone for a long time. ...
INSTALLATION INSTRUCTIONS The installation comes under the exclusive responsibility of specialists. The installer is held to respect the legislation and the standards enforce in his home country. How to stick the gasket: The gasket supplied with the hob avoids all infiltration of liquids in the cabinet. His installation has to be done carefully, in conformity of the following drawing.
ELECTRICAL CONNECTION The installation of this appliance and the connection to the electrical network should be entrusted only to an electrician perfectly to the fact of the normative regulations and which respects them scrupulously. Protection against the parts under tension must be ensured after the building-in. ...