Foster 7300000 Use And Installation Manual page 6

BUILT-IN SIZES
Installing the foam
gasket
(for glass appliances)
The fixing of the appliance to the worktop is achieved by using the brackets supplied in the accessory bag. After
applying the gasket and positioning the top in the recess hole, position the brackets and secure them using the screws
provided. Use the holes in the four corners of the hob.
Before inserting the appliance into the opening in the kitchen worktop, the supplied foam
gasket must be attached to the lower side of the glass.
Do not install the appliance without the foam gasket!
The gasket should be attached to the appliance in the following way:
Remove the protective film from the gasket.
Attach the gasket to the lower side approximately A=2-3 mm from the edge. The gasket
must be attached along the entire length and should not overlap at the corners.
When installing the gasket, make sure that the glass does not come into contact with any
sharp objects.
7300000
7380645 7381645 7381245 7382645 7383645 7384645
A 920 290
580
B 520 510 510
908
C 270 560
D 504 480
480
E 55 mm 55 mm
F 6 mm 6 mm
G
H
24
4
580 770 770
510 510 510
560 750 750
480 480
480
55 mm 55 mm 55 mm
6 mm 6 mm 6 mm
860
510
840
480
55 mm
6 mm