Cookware Detection - Foster 7300000 Use And Installation Manual

COOKWARE DETECTION

Cookware is automatically detected when the hob is switched on.
Do not place metal objects such as knives, forks, spoons and lids on the surface of the
hob, they may become hot.
•There are no fixed cooking zones. The pot can be placed and operated anywhere inside the cooking area of the
cooktop.
•The pot is displayed according to its size and position on the cooktop in the main screen.
•There are three standard pot sizes: small, medium, big. Pots are always displayed with a round shape.
COOKWARE PLACING
•The glass ceramic surface is dimensioned to accommodate up to a maximum of 6 containers simultaneously.
•For correct pot detection and for efficient heat transmission is preferable to use circular pans of the following sizes:
Min. circumference: 145 mm
•Small pots between 100-145mm in circumference won't be detected everywhere in the cooking area.
•Oversize cookware must be placed on the back section of the cooking area only.
•Large pots might appear on the display as two different elements. Move the pot slightly or place it again on the
surface until it is recognised.
•Always keep pots a few centimeters apart.
page 25 of 113
Pots should only be placed inside the cooking area, never place them too close to the display.
company: 0083 / E.G.O. Germany (E.G.O. Elektro-Gerätebau GmbH)
There are three standard pot sizes implemented in the UI: small, medium, big. Pots are always disp
with a round shape. Fourth pot size is only used in display conflict cases.
4.2.5 Pot Selection and Power Regulation
Precondition
The cooktop is switched on and a new pot is placed on the cooktop.
 The pot is displayed in the main screen
 The new pot will only be automatically selected by the system if no other pot has been sele
before
 Selection mode is shown by a little animation with two function icons around the pot. Additi
power level slider appears on the bottom part of the display
 Select the desired power level on the slider
technical customer documentation
company: 0083 / E.G.O. Germany (E.G.O. Elektro-Gerätebau GmbH)
4.2.2 Switching ON and OFF
Precondition
The cooktop is in standby mode, i. e., it is connected to the power supply voltage and the self-test h
performed successfully.
 Touch the ON/OFF SmartKii.
 The cooktop is turned on.
No logo is implemented in the E.G.O. standard variant. A customer brand logo can be displayed opt
Max. circumference: 280 mm
document id.: 90.60113.039-001-08-A / state: 120 - at review
designation: Lumio customer documentation
9
p