Table of Contents
Advertisement
"Pull to Open" Installation
Do not install the actuator in
fully extended (Bottomed out)
position. This will damage the
arm. See page 11 to prevent
this from happening.
Attaching Brackets to Surfaces
Bolt or weld brackets to gate and support post/wall.
Rear Bracket Options
Assemble straight out (shown)
or 3 different angles.
Note: The brackets must be perpendicular (Plumb) to the gate and wall/post and
horizontally level. If welding brackets to surfaces, weld completely around brackets.
Support Bar
A support bar must span
the entire length of the
gate to support the gate
pickets. The pickets will
bend if not supported.
Gate in Closed Position
6003-065-F-4-20
Front Bracket Pivot Point
Front Bracket
Closed Position
Cut Off
Excess
Bracket
Sleeve Anchors
(Not Supplied)
Front Bracket
Bolt or weld to gate.
2"
2
1 / 2
"
Angled Configurations
Angles will reduce operators
distance from wall. See page 11.
Top
Middle
Bottom
47.5" Closed Position
Gate Hinge Pivot Point
90°
Hardware
(Not Supplied)
Wall
3"
5
Straight
1 / 2
Actuator arm MUST be level!
Rear Bracket Pivot Point
7"
7"
Open Position
Cut Off
Excess
Bracket
"
Bottom Installation Note:
Make sure that the
operator is mounted high
enough off the ground
that it will NOT come in
contact with standing or
flowing water. This will
damage the operator.
9
Advertisement
Table of Contents
