Western Digital OpenFlex Data24 Installation Manual page 19

Installation Guide
Figure 12: Captive Screws
Step 3 : (Optional)
Assembly Installation Procedure (page 16)
Step 4 : Connect the data and power cables to the enclosure.
a. Move to the rear of the rack and connect the Ethernet Cables into the Ethernet Management
ports.
Figure 13: Connecting RJ45 Ethernet Cable to Management Port
b. Connect the QSFP28 cables into all of the IOM ports.
If your configuration contains a CMA, proceed to the
Attention: The system requires a power source that can support a voltage range of
200V - 240V.
Cable Management Arm (CMA)
.
1. Installation
1.5 Installation Procedure
14