Supermicro SuperStorage SSG-6049SP-DE1CR60 User Manual page 98

SuperStorage Server SSG-6049SP-DE1CR60/90 User's Manual
Hot Plug (SATA Port 0~ Port 5)
Select Enable to support Hot-plugging for the device installed on a selected sSATA port
which will allow the user to replace the device installed in the slot without shutting down
the system. The options are Enable and Disable.
Spin Up Device (SATA Port 0~ Port 5)
Select Enable for Staggered Spin Up support which will allow the SATA devices specified
by the user to spin up one at a time during system boot in an effort to prevent all hard
drive disks from spinning up at the same time, causing a power surge. The options are
Enable and Disable.
sSATA Device Type (SATA Port 0~ Port 5)
Use this feature to specify if the device installed on the sSATA port specified by the user
should be connected to a Solid State drive or a Hard Disk Drive. The options are Hard
Disk Drive and Solid State Drive.
*If the feature, Configure SATA as, is set to RAID, the following features will become
available for user's configuration:
sSATA RSTe Boot Info
Select Enable to provide the full int13h support for sSATA controller attached devices. The
options are Disable and Enable.
sSATA RAID Option ROM/UEFI Driver
Select EFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Disable, EFI, and Legacy.
sSATA Port 0~ Port 5
Hot Plug (SATA Port 0~ Port 5)
Select Enable to support Hot-plugging for the device installed on a selected sSATA port
which will allow the user to replace the device installed in the slot without shutting down
the system. The options are Enable and Disable.
Spin Up Device (SATA Port 0~ Port 5)
Select Enable for Staggered Spin Up support which will allow the SATA devices specified
by the user to spin up one at a time during system boot in an effort to prevent all hard
drive disks from spinning up at the same time, causing a power surge. The options are
Enable and Disable.
98