Supermicro SuperStorage SSG-6049SP-DE1CR60 User Manual page 45

Installing the Mezzanine Card
1. Power down the server and extend the node to which you want the card installed from
the chassis.
2. Align the mezzanine card with the mezzanine tray.
3. Secure the mezzanine board to the tray with screws as shown below.
4. Flip the assembly over. Make sure the left and right latches are in the unlocked position,
then align the tray to its position on the motherboard and lower it into place.
5. After making sure it is fully seated into the motherboard, rotate the latches forward to
their locked position.
6. Carefully push down on the middle section to ensure the connectors are fully seated.
7. Push the node back into the chassis.
Latch
Latch
Chapter 3: Maintenance and Component Installation
Figure 3-3. Installing the Mezzanine Card
45